Printer timing belt

Batch BAT000767 ยท of SKU000748

This batch

BAT000767

Locations

BinIdentifierQuantityType

Physical quantity evidence

No uncertain physical quantities.

Codes

None

Batch properties

Description
Removed from an Ender 3 according to owner. Original purchase and exact printer revision/axis unknown; condition and wear not assessed.
Created through automation
true
Automation source or version
Inventory Assistant 0.1.0+codex.20260919214048 (host report); gpt-6-astra (host report)

Shared details from SKU000748

Printer timing belt

These details belong to the SKU and are shared by its batches.

Toothed drive belt. Owner reports approximately 800 mm length and 5.7 mm width; tooth pitch estimated at about 2 mm but uncertain. Likely nominal 6 mm-wide GT2/2GT; nominal pitch and tooth profile deliberately unset, not verified from markings or measurement. End configuration (open-ended or closed-loop), exact printer axis and reinforcement material are unknown. Length is owner-reported overall length, not a verified pitch-line circumference. Comparison only: Creality lists a 2GT W6 replacement belt, https://mvip.creality.com/en/goods/goodsDetail/1091 ; that 1000 mm replacement listing is not this piece's measured length or purchase provenance.

Shared properties (5)
Belt length
800 mm
Belt width
5.7 mm
Material
Rubber (owner description)
Created through automation
true
Automation source or version
Inventory Assistant 0.1.0+codex.20260919214048 (host report); gpt-6-astra (host report)